No KYC · Non-custodial · Private

Trade Ethereum for Monero

ETH → XMR on Monero mainnet: a non-custodial swap with no KYC. Quote the amount, send Ethereum from your wallet, and receive Monero at the address you name after confirmations.

    Start swap

    You Send
    -
    ▼
    All fees included
    Estimated rate: -
    You Get
    -
    ▼

    How the swap works

    1. Type the ETH amount and paste your Monero payout address on Monero mainnet.

    2. Press Exchange to open the live quote and the deposit address for this order.

    3. Broadcast ETH to that deposit. After the required confirmations, XMR is sent to your wallet.

    Check these before you send

    • Ethereum deposits usually confirm within a few blocks (about 12 seconds each).
    • When gas spikes, the send costs more, but inclusion is still typically fast.
    • Send ETH on Ethereum mainnet only — not BSC, Base, or other L2s unless your order says otherwise.
    • If XMR has not appeared yet, wait a few minutes and refresh the wallet. When the order already shows a payout tx, contact support with your order ID.
    You send

    Ethereum — smart-contract base layer

    ETH is the gas and settlement asset of Ethereum mainnet — staking, DeFi, and most contract activity run here.

    Send ETH on the listed chain

    Use an Ethereum mainnet wallet for deposits. L2 or alternate-chain sends may not be credited.

    Leave enough ETH in your wallet to cover gas on top of the swap amount.

    You receive

    Monero — privacy on by default

    Monero uses ring signatures and one-time addresses so amounts and destinations stay confidential on-chain.

    XMR payout not showing?

    Wait for wallet sync to complete — Monero often needs several minutes to reflect incoming outputs.

    If the order lists a payout tx but your synced wallet shows nothing, contact support.

    Receiving XMR with privacy intact

    Monero payouts use one-time addresses — your wallet must finish scanning recent blocks to display the balance.

    • Use a fresh subaddress for each swap rather than reusing old receive addresses.
    • Compare your wallet block height with a public explorer before assuming a payout failed.
    • Allow extra time after the order shows sent — privacy features can delay wallet display.

    Read before you send

    Wrong-network deposits and address mistakes are the usual failure modes — start with these notes.

    All swap safety guides

    Coin swap hubs

    More no-KYC swap pairs and guides for each asset.

    Other pairs on this route

    Frequently asked questions

    Does ETH to XMR require KYC or an account?

    No. PeakSwap does not ask for a profile, ID documents, or a hosted balance for Ethereum to Monero.

    How long until XMR arrives?

    Many orders finish in a few minutes. Ethereum mainnet deposit confirmations and Monero mainnet payout time set the wait.

    Do you hold ETH or XMR for me?

    No. You send ETH from a wallet you control and XMR is paid to the address you provide — PeakSwap does not keep a user wallet.

    What if I send ETH on the wrong chain?

    Use Ethereum mainnet exactly as shown on the order. A wrong-network send may not be credited — read the swap safety notes first.