No KYC Β· Non-custodial Β· Private

Trade Ethereum (Base) for Ethereum

A no-KYC ETH to ETH route: send from your wallet, receive on Ethereum mainnet. The rate is shown before you commit. After the Ethereum (Base) deposit confirms, Ethereum is paid out automatically β€” usually in minutes.

    Start swap

    You Send
    -
    β–Ό
    All fees included
    Estimated rate: -
    You Get
    -
    β–Ό

    How the swap works

    1. Type the ETH amount and paste your Ethereum payout address on Ethereum mainnet.

    2. Press Exchange to open the live quote and the deposit address for this order.

    3. Broadcast ETH to that deposit. After the required confirmations, ETH is sent to your wallet.

    Check these before you send

    • Base confirmations are usually fast β€” often within a minute.
    • Send ETH on Base mainnet only β€” not Ethereum L1, Optimism, or Arbitrum unless your order says otherwise.
    • Use a Base-compatible wallet and address (0x…). Leave enough ETH on Base for gas on top of the swap amount.
    • If ETH has not appeared yet, wait a few minutes and refresh the wallet. When the order already shows a payout tx, contact support with your order ID.
    You send

    ETH on Base β€” Coinbase L2

    Native ETH on Base β€” Ethereum's value on Coinbase's L2 with low fees, fast finality, and growing on-chain activity.

    ETH on Base mainnet

    Use a Base wallet for deposits. Ethereum mainnet ETH is a different network β€” wrong-chain sends may not be credited.

    Leave enough ETH on Base for gas in addition to the amount you swap.

    You receive

    Ethereum β€” smart-contract base layer

    ETH is the gas and settlement asset of Ethereum mainnet β€” staking, DeFi, and most contract activity run here.

    ETH payout not showing?

    Check the order page for a payout transaction hash first.

    Confirm your wallet is on Ethereum mainnet and fully synced.

    ETH payout timing

    Most payouts land within minutes once your deposit confirms β€” Ethereum blocks are ~12 seconds apart.

    ETH must land on the listed chain

    • Payouts go to Ethereum mainnet β€” not BSC, Base, Arbitrum, or other L2s unless your order explicitly lists them.
    • Double-check the address you paste: one wrong character sends funds to an unreachable wallet.
    • Self-custody wallets (MetaMask, Rabby, hardware devices) are recommended for long-term holding.

    Float vs fixed rate on ETH payouts

    The rate mode you pick at the top of the swap widget affects how your final ETH amount is calculated.

    • Float rate follows the market until your deposit confirms β€” best when mempools are quiet.
    • Fixed rate locks the quote for a short window β€” useful when ETH price is moving quickly.

    Read before you send

    Wrong-network deposits and address mistakes are the usual failure modes β€” start with these notes.

    Ethereum gas & gwei for swaps How gas spikes affect deposit cost and confirmation speed. Deposit amount must match exactly Under- and over-payments can delay or fail automated crediting. What each swap status means From awaiting deposit to complete β€” read each status on your order page. How to track swap order status Use your exchange ID and read each status on the order page.

    All swap safety guides

    Coin swap hubs

    More no-KYC swap pairs and guides for each asset.

    ETH Swap Ethereum (Base) (ETH) β€” no KYC hub ETH Swap Ethereum (ETH) β€” no KYC hub

    Other pairs on this route

    ETH β†’ ETH ETH to ETH on PeakSwap: no KYC, no hosted balance, payout to the address you name. ETH β†’ BTC ETH to BTC on PeakSwap: no KYC, no hosted balance, payout to the address you name. ETH β†’ XMR ETH to XMR on PeakSwap: no KYC, no hosted balance, payout to the address you name. ETH β†’ USDT Convert Ethereum (Base) into Tether without opening a profile. Quote first, then send from your wallet. ETH β†’ USDT ETH to USDT on PeakSwap: no KYC, no hosted balance, payout to the address you name. ETH β†’ USDC Convert Ethereum (Base) into USD Coin without opening a profile. Quote first, then send from your wallet. ETH β†’ SOL Convert Ethereum (Base) into Solana without opening a profile. Quote first, then send from your wallet. ETH β†’ ZEC Convert Ethereum (Base) into Zcash without opening a profile. Quote first, then send from your wallet. ETH β†’ BNB Swap Ethereum (Base) for BNB with no account and no KYC. Wallet-to-wallet payout after confirmation. ETH β†’ LTC Trade ETH to LTC privately β€” non-custodial, no signup, automatic payout. ETH β†’ XRP Swap Ethereum (Base) for Ripple with no account and no KYC. Wallet-to-wallet payout after confirmation. ETH β†’ TRX Swap Ethereum (Base) for Tron with no account and no KYC. Wallet-to-wallet payout after confirmation.

    Frequently asked questions

    Does ETH to ETH require KYC or an account?

    No. PeakSwap does not ask for a profile, ID documents, or a hosted balance for Ethereum (Base) to Ethereum.

    How long until ETH arrives?

    Many orders finish in a few minutes. Base mainnet deposit confirmations and Ethereum mainnet payout time set the wait.

    Do you hold ETH or ETH for me?

    No. You send ETH from a wallet you control and ETH is paid to the address you provide β€” PeakSwap does not keep a user wallet.

    What if I send ETH on the wrong chain?

    Use Base mainnet exactly as shown on the order. A wrong-network send may not be credited β€” read the swap safety notes first.